IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons, including the following:
1) Read all instructions before using this heater.
2) Heater is hot when in use. To avoid burns do not let bare skin touch hot
surfaces. Use handle to move heater. Keep combustible materials such as
furniture, papers, clothes, and curtains at least 3 feet from the front of the
heater and keep them away from the sides and rear.
3) Extreme caution is necessary when any heater is used by or near
children or invalids and whenever the heater is left operating and
unattended.
4) Always unplug heater when not in use.
5) Do not operate any heater with a damaged cord or plug or after the
heater malfunctions, has been dropped or damaged in any manner.
Discard heater, or return to authorized service facility for examination
and/or repair.
6) Do not use outdoors.
7) This heater is not intended for use in wet or very humid locations. Never
locate heater where it may fall into water.
8) Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be
tripped over.
9) To disconnect heater, turn controls to off, then remove plug from outlet.
10) Connect to properly grounded outlets only.
11) Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
12) To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces or unstable surfaces where the heater
may upset or where openings may become blocked.
13) A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint, or flammable liquids are used or stored.
14) Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
15) Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or power strip (power tap). DO NOT CUT OFF
PLUG AND WIRE DIRECTLY.
16) Risk of fire. Do not use as a residential or household heater.
“SAVE THESE INSTRUCTIONS”
PLEASE READ BEFORE OPERATING
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from box. (Please SAVE the
Box for off season storage.
2. Attach the handle using knobs provided.
3. Make sure the heater is switched OFF (FULL counter-clockwise
position) before plugging the heater into the outlet. Connect to
properly grounded outlets only. Note: The power cord has a NEMA
#6-20P plug that will only fit in the outlet one way. If it does not fit
contact your electrician to replace your outlet.
4. Place heater only on a firm level surface, free from obstructions
and at least 3 ft. away from any wall or other objects such as
curtains, plants, etc.
5. Avoid overloading your circuit by not using other high wattage
appliances in the same outlet.
HOW TO USE YOUR HEATER
1. Completely uncoil the cord and plug heater directly into a 240 Volt
grounded AC wall outlet. Be sure the plug fits tightly. A loose fit will
cause overheating and damage the plug. Plug and cord may feel
warm during normal usage. DO NOT USE EXTENSION CORDS.
DO NOT CUT OFF PLUG AND WIRE DIRECTLY.
2. Thermostat: Turn to highest setting until room is comfortable. Then
slowly rotate the knob counter clockwise (left) until the heater
cycles OFF. At this SET POINT the heater will cycle On and Off to
maintain this comfort level.
3. It is necessary to allow the heater to cool for 10 minutes before
restarting.
CAUTION
Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause FIRE, ELECTRIC SHOCK
or injury to persons.