8. GENERAL USAGE OVERVIEW
Operator
Operator is a user with the privilege to control measurement sessions. Operator can start or stop the measurement
sessions and should watch over the measurement and progress.
8.1.4 Admin and Operator Modes
As with the two kind of users, there are two basic modes with different web pages on SAFETIS web server.
If administrator logs in to web server, the ”Admin Mode” starts. If operator logs in, the ”Operator Mode” starts.
Admin Mode
Admin mode takes the administrator through several tabs and web pages with settings. The administrator should
follow these tabs and prepare settings for the operator and future measurement.
Please refer to chapter 10 for further details.
Operator Mode
Operator mode is just a single web page. Upon operator logging, the measurement session can be started or
stopped.
Please refer to chapter 11 for further details.
8.1.5 ROI
One of the most important settings is so called Regions Of Interests, or ROIs.
ROI is an point or an area of a thermocamera image upon which the measurement computations and evaluations
are performed. The SAFETIS measurement can have several ROIs.
For further information, please refer to chapter
??
.
8.2 Measurement overview
When operator logs in, the measurement can be started. The SAFETIS will not do any measurement neither will
it produce any digital signal until the operator starts the measurement session.
8.2.1 Measurement session
When measurement session starts, the SAFETIS will perform an image calibration and produce digital outputs
according to the previously created settings.
It will do individual measurements and evaluate the results. Each single measurement can consist of data
collecting from incoming thermal images.
E‐mail and Web
[email protected]
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Version 210224 EN, 24
th
Feb, 2021
All pictures are only for illustration.
Real values may vary.
17
