CONTENTS OF HARDWARE KITS
Standard Workstation
with Rear Angleframe
Standard Workstation
with Modesty Panel
ASSEMBLY INSTRUCTIONS
For Job No.:
Assembly Tips
• Do not remove components from cartons prior to assembly, as
components do not bear part numbers. Use packing list to locate
each component by its' carton number.
• Sort hardware kits by number. Do not open bags until ready for use.
• Assemble basic unit first, then add any optional accessories.
For Optional Modesty Panel:
7 ea. - #8x3/4" Hex Washer Head Tek
Screws
4
Kit
#21
Kit
#84
4 ea. - 5/16-18X3/4" Hex Hd Cap Screws 4 ea. - Flat Clips
4 ea. - 5/16" Flat Washers
2 ea. - Z Clips
2 ea. - 1/4" Flat Washers
(Round
Head
Machine
Screws)
Kit
#81
8 ea. - 5/16-18 x 3/4" HHMS
(Hex Head Machine Screws)
8 ea. - 5/16" Flat Washers
Lit #400-20 (Rev 05/16)
Call 800-258-9700
•
Fax 603-622-0174
WORKPLACE MODULAR SYSTEMS, LLC.
562 Mammoth Rd • Londonderry, NH 03053
®
ASSEMBLING THE BASIC TABLE
3
MOUNTING THE WORKSURFACE
Important:
Install any optional
TYPE A
accessories
before
continuing to Step 3.
If unit is equipped with a Conductive Top,
please see enclosed sheet for additional
information regarding conductive tops.
(Kit #84)
Position TOP on completed
assembly, with rear edge flush with
rear of Frame, and centered over each
end.
Note:
Top will overhang 2" at each
end and 1" at front.
Pre-installed metal inserts are located
on underside of Top for ease in fasten-
ing. Use fasteners from Kit #84 to
secure Top to Frame, noting that flat
clips are used at each end, while "Z"
clips are used at center.
MODULAR BENCH SYSTEMS
Z-CLIP
(Kit #84)
FLAT CLIP
(Kit #84)
