ENG
ENG
Wanì light 2 - owner’s manual
Wanì light 2 - owner’s manual
12
13
2.1.3 - Inserting the reserve parachute
Insert the parachute in the harness container with the handle visible
toward the outside and with the ropes facing downward.
Position the handle in its specific lodging and ensure that the Velcro
sewn on the handle attaches to the Velcro on the harness.
Introduce a thin rope (paragliding funicular strip type) into each elastic
loop which you will use to help close the container. Introduce the ela-
stic loops into the smallest of the eyelets under the handle.
CAUTION:
To prevent abnormal side loads, the cable is hooked to both loops on
their respective shoulder-straps. Not only to one of the two.
Do not put any objects inside the bridle container.
Take the bridle cover zip and the second zip that closes the other end
of the container to their start point under the emergency parachute
handle. Close the zip on both sides about 20 cm.
Close the external part of the container as shown in the photo, taking
care during this phase that none of the zips open. Insert the two plastic
yellow pins into the elastic loops and then under the cover arranged
between the two.
After having closed all container parts, it is advisable to check that the
two zips under the opening system have been closed correctly.
The cord must absolutely be removed at the end of this phase, and
must be extracted slowly in order to avoid damaging the elastic loops
due to excessive friction between the parts.
In the end the two zips should be completely closed until introducing
the zips pull under the cover at the opposite end.
