Remote LDSS IOP reserve power
Object 2232h (Parameter 562)
This value may be used to modify LDSS reserve power value [kW] for island operation via
interface.
Notes:
• Parameters “5760 IOP Reserve power”, “5648 IOP Reserve power 2” and LM
•
“120604 IOP Reserve power 2” are not overwritten by this write command.
• The last change either via interface or via the parameter selected with the LM is
•
effective.
• If there is no change anymore, the last change will be kept until power cycling the
•
device.
• After power cycling, the parameter value is used until the easYgen receives a
•
different value via interface.
• The parameter alignment is still done with the active parameter value.
•
Remote LDSS MOP reserve power
Object 2233h (Parameter 563)
This value may be used to modify LDSS reserve power value [kW] for parallel to mains
operation via interface.
Notes:
• Parameter “5768 MOP Reserve power”, “5649 MOP Reserve power 2” and LM
•
“120605 MOP Reserve power 2” are not overwritten by this write command.
• The last change either via interface or via the parameter selected with the LM is
•
effective.
• If there is no change anymore, the last change will be kept until power cycling the
•
device.
• After power cycling, the parameter value is used until the easYgen receives a
•
different value via interface.
• The parameter alignment is still done with the active parameter value.
•
Free analog values
The device provides identifier “Free analog values” for receiving 16 bit signed integers for
free purposes. The values are available in the AnalogManager group 24. Refer to
“9.2.9.3.4 Free Analog Values”
External DI request (1 to 16)
Object 3F4Eh (Parameter 8014)
This object is required to receive the state of the external discrete inputs 1 to 16 (e.g. of
a Phoenix expansion card). The data type is UNSIGNED16.
1070
easYgen-3000XT Series
B37574
9 Appendix
9.2.9.1 Receive Data (sent from remote control to the easYgen)
Released