Manual 37429
easYgen-2000 Series - Genset Control
© Woodward
Page 9/41
Application Mode {0}
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
This application mode may be used for isolated operation applications. In this case, the easYgen will function as
an engine control.
Figure 2-1: Application mode {0}
The easYgen requires in all application modes the feedback reply from the circuit breakers. These replies are
used to define, whether it controls frequency, shares the load with other gensets, or performs active load control.
The following feedback signals are used in this application mode and fixed to the respective discrete inputs:
•
DI 7 "Reply MCB" (mains parallel; normally closed (break) contact)
•
DI 8 "Reply GCB" (normally closed (break) contact)
NOTE
If the easYgen is intended to be operated in parallel with the mains, the mains voltage measuring in-
puts must be connected.