Woodstock Shop Fox W1888, Owner'S Manual

Page: 39 / 97

-36-
Model W1888 (For Machines Mfd. Since 10/20)
O
PE
R
ATIO
NS
Blade.Installation
Review this section, even if your saw blade came pre-
installed.
3. Push arbor lock (see Figure 44
) in and turn blade
until it locks in place.
To.reduce.risk.of.injury,.
always. disconnect.
power. to. saw. before.
changing. blades.. Since.
blade. is. sharp,. use.
extra. care. and. wear.
gloves. when. installing.
it.
4. While pressing arbor lock, use included arbor wrench
to loosen and remove arbor nut, flange, and blade
(see
Figure 45
).
Note: Arbor nut has right-hand threads; rotate
counterclockwise to loosen.
Figure 45 . Example of removing table saw
blade.
Figure 44 . Location of arbor lock.
Arbor Lock
Items.Needed. Qty
Leather Work Gloves ..................................... 1 Pair
Arbor Wrench ....................................................1
To install blade, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Raise arbor all the way up, then remove blade
guard, spreader/riving knife (see
Pages 38 & 41),
and table insert.