Product
Description
Designed for use with hoisting equipment, MRTALPCH6-DC3 lifters support loads using vacuum and
manipulate loads using manual 180° rotation and mechanically assisted, manual 90° tilt motions.
Model
Number
MRTALPCH611LDC3
MRTALPCH6
HV11
DC3O
MRTALPCH610CDC3O
Vacuum Pads
(6 each, standard rubber
1
1...... Available with other rubber compounds for special purposes (see
www.WPG.com
).
)
11" [28 cm] nom. diameter,
lipped (Model G3370)
10" [25 cm] nom. diameter,
lipped (Model HV11)
10" [25 cm] nom. diameter, con-
cave (Model G0750)
Pad Spread
---------------------------- (to outer edges) ----------------------------
Maximum
79¼" x 12" [201 cm x 30 cm]
78¼" x 11" [199 cm x 28 cm]
77¼" x 10" [196 cm x 25 cm]
Minimum
53¾" x 12" [137 cm x 30 cm]
52¾" x 11" [134 cm x 28 cm]
51¾" x 10" [131 cm x 25 cm]
Maximum
Load Capacity
2
2...... The Maximum Load Capacity is rated at a vacuum of 18 Hg [-60 kPa] on clean, smooth, nonporous flat surfaces with a friction coefficient of 1. Pad
compound, load rigidity, strength, surface conditions, overhang, angle, center of gravity and temperature can also affect the lifting capacity. A qualified
person should evaluate the effective lifting capacity for each use (see definition under “Rated Load Test” on page 33).
Per-Pad
184 lbs [83.5 kg]
150 lbs [68.5 kg]
150 lbs [68.5 kg]
Total with 4 Pads
700 lbs [320 kg]
600 lbs [270 kg]
600 lbs [270 kg]
Total with 6 Pads
1,100 lbs [500 kg]
900 lbs [410 kg]
900 lbs [410 kg]
Lifter
Weight
130 lbs [59 kg]
Power
System
12 volts DC,
5
.5 amps
Battery
Capacity
7 amp-hours
Rotation
Capability
Manual, 180°, with latching at each ¼ turn (when required)
Tilt
Capability
Manual, 90°, with automatic latching in upright position and four-bar tilt linkage that provides mechanical
advantage
Product
Options
Available
with Remote Control System – FCC, CE and ICC certified. See separate instructions about other
options.
Operating
Elevation
Up to 4,500' [1,370 m]
Operating
Temperatures
32° — 104° F [0° — 40° C]
Service
Life
20,000 lifting cycles, when used and maintained as intended
3
3...... Vacuum pads, filter elements and other wear-out items are excluded.
Software
Version
Intelli-Grip
®
7.6
ASME Standard
BTH-1
Design Category "B", Service Class "0" (see
for more information)
Rev 1.0/12-19
MRTALPCH6-DC3(RC): #35125
3
!!–CE–!!
This symbol appears only when a CE Standard is different from other applicable standards. CE requirements are
mandatory in the European Union, but may be optional elsewhere.
SPECIFICATIONS
