WOOD'S POWR-GRIP MRTALPCH610CDC3O, Operating Instructions Manual, Page: 27 / 48

Make sure load is positioned correctly on lifter (as previously
directed).
Never disengage rotation and tilt latches at the same time, because this could result
in load damage or personal injury.
Rev 1.0/12-19 MRTALPCH6-DC3(RC): #35125 25
T
O
T
ILT THE
L
OAD
1) Make sure the load has enough clearance to tilt without contacting anyone or anything.
2)
2A
3A
Use a control handle
(circled in fig. 2A) on the
pad frame to keep the load
under control at all times.
3) If the pad frame is latched,
pull the tilt release lever
(fig. 3A) to disengage the
tilt latch.
Unbalanced load
may rotate
unexpectedly when
latch is disengaged.
4) Lift upward or press
downward on the control
handle to tilt the load as
required.
1
Keep hands and
fingers away
from tilt linkage.
Note: See “L
OAD
C
HARACTERISTICS
”
on page 13 about allowable
overhang.
1..... Due to the tilt linkage design, load force on the control handle changes direction during the tilt.
OPERATION