Copyright Woodpeckers Inc, 2012
Copyright Woodpeckers Inc, 2012
Micro Adjust Assembly Instructions
These instructions explain how to install the Micro Adjust accessory to
the Woodpeckers Super Fence.
Begin by installing the (4) long screws down through the main block.
Loosely start the oval nuts from the bottom. Next install the (2) short
screws and washers through the fence mounting plate as shown.
Loosely start oval nuts on these two as well.
California Proposition 65 Warning: This product may contain chemicals known to the
State of California to cause cancer and birth defects or other reproductive harm.
Main block
Long screws
Fence mounting plate
Oval nuts
Steel washers
Short screws
Once the fence Micro Adjust is approximately centered on the fence,
slide both it and the fence toward the center of the table. During this
step you need to align the bolt heads below the track with the track
slots in the table.
Once the Micro Adjust is flush with the back of the table and centered
to the fence, tighten the two clamping knobs.
To fine tune the position of the router fence itself, make sure the two
clamp knobs holding the fence are loosened. Then turn the adjustment
knob to move the fence and finally re-tighten the fence clamping knobs.
Also make sure the Micro Adjust clamping knobs are tight.
BEFORE ROUTING WITH YOUR FENCE, YOU MUST TIGHTEN THE TWO
FENCE CLAMPING KNOBS AND THE TWO MICRO ADJUST CLAMPING
KNOBS.
Adjustment knob (1)
Micro Adjust Clamping knobs (2)
Fence clamping knobs (2)
Track aligned with back edge of
router table