Woodland Mills Woodlander, Operator'S Manual, Page: 45 / 68

2018-2023 Woodlander ™ (MAX) Operator’s Manual
Drill four (4) holes for the lock-down plates using the provided 10 mm [
⅜
in] drill bit. Measure
64- ½ in [164 cm] from the rear edge of the track rail ( not the carriage stop) to the rear post of
the sawhead. Insert a locking pin into each hole as they are drilled. Secure each locking pin
with a linch pin.
0001675-M-EN: Rev C Page of 43 64 07-Oct-2022
64- ½ in [164 cm]
WARNING!
Use cutting oil when drilling holes for lock-down brackets or
else the heat generated could ruin the drill bit and produce a
rough surface finish.