Woodland Mills Woodlander XL, Operator'S Manual

Page: 10 / 64

Woodlander ™ XL Operator's Manual
3. TRACK RAILS, JOINING GUSSETS, MIDDLE BUNK
Using the hardware listed below, assemble the gussets to the track as shown on the next page.
Torque all bolts per the table in section
BOLT TORQUE SPECIFICATIONS .
Track components listed in these tables are not included with the trailer package, namely track
rails, joining plates, bunks, and carriage stops. These components are found in the sawmill
crate. If the trailer was purchased for an existing sawmill (i.e. the sawmill is currently
assembled), the track will need to be disassembled prior to building the trailer.
When assembling the track, ensure the gussets are flush with the track rails as shown in the
graphic below. Measure diagonally to check for squareness.
12x
M10 X 30 mm
Flanged Hex
Bolt
1x Middle Bunk
12x
M10 Flanged
Lock Nut
4x Joining Plate
2x Track Rail 2x Joining Gusset
WDLRXL-MY2020: Rev A Page of 8 60 27-Sep-2019
Use the fasteners included with the
sawmill trailer to assemble the
track. The fasteners included with
the sawmill track will not be used.
HM126/HM130 = 30- ½ in [775 mm] Track Width
HM130MAX = 37 in [940 mm] Track Width
Flush Flush