Woodland Mills MULTILANDER, Operator'S Manual, Page: 28 / 48

Multilander ™ Operator’s Manual
JACK SUPPORT
Slide the jack support over the tongue until it is 4- ½ in [114 mm] from the front face of the
tongue. This allows for accessories (sold separately) to be assembled to the trailer without
having to adjust the position of the jack support later. The jack support is installed in the same
orientation no matter if the coupler is
above or below the tongue.
Secure the jack support to the tongue with the chassis clamp, two (2) M10 X 60 mm flanged hex
bolts, and two (2) M10 flanged lock nuts.
When tightening the bolts, tighten the left and right sides of the chassis clamp incrementally until
the clamp is fully seated. Ensure the clamp does not sit askew.
MLTR-MY2020-EN: Rev B Page of 26 44 22-Jan-2021
4- ½ in [114 mm]
Jack stand mounting boss always on this side