HM126 Operator’s Manual
HEAD LOCK-DOWN PLATES
Woodland Mills sawmill trailer owners only
If a Woodland Mills sawmill trailer was purchased with this sawmill, the head lock-down plates
can be loosely installed prior to standing the sawhead upright. The lock-down plates come with
the sawmill trailers and are not included with the sawmill.
Disassemble each carriage wheel and discard the short spacers as they are no longer
necessary. Assemble one (1) lock-down plate on each side of the long spacers—between the
carriage legs—and then reassemble the carriage wheels. Do not fully tighten the carriage
wheel bolts.
See section,
HEAD LOCK-DOWN PLATES
, in the sawmill trailer Operator Manuals to complete
the lock-down plate installation once the sawmill is on the trailer.
8x
Head Lock-
Down Plate
HM126-MY2021-EN: Rev F
Page
of
33
112
14-Jul-2021
Discard short spacers
Loosely assemble
lock-down plates
Ensure the longer lock-down plate leg will sit above
the wheel sweeper nut when the sawhead is stood
upright. This lets the lock-down plates swivel up
inside the carriage legs avoiding possible damage
until the sawhead is ready to be set on the track.
