Woodland Mills BUSHLANDER, Operator'S Manual

Page: 26 / 60

Bushlander ™ Operator’s Manual
LOCK-DOWN PLATE INSTALLATION
Remove the eight (8) spacers from the carriage wheel axles and discard the four (4) short
spacers. Only the four (4) tall spacers will be reused in the next steps.
Using the provided M6 X 40 mm and M6 X 25 mm bolts, install the lock-down plates in place of
the short spacers with the taller spacer sandwiched between. Reuse the four (4) M6 flat
washers from the wheel sweepers on the sawmill when replacing the bolts.
BHLR-MY2020-EN: Rev B Page of 24 56 20-Aug-2020
M6 X 40 mm
through sweepers
M6 X 25 mm
Discard short
spacers
Older model sawmills
(pre-2020) used a single
spacer design between
the carriage plates.
Replace these with the
supplied spacer kit—part
number 0003702.