NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND
TIGHTENED PROPERLY AND SECURELY.
VENETO SIDE TABLE
WDC-VEN-ST
Assembly Instructions
Step 1: Remove protective wrapping first. Then lay all parts on floor and identify all parts packed in
carton against attached parts list to make sure all parts are present.
Step 2: Place a protective soft material on floor first. Turn table frame (B) upside and lay onto the
protective material. Then carefully lay stone top (A) upside down inside the top frame (B) on the
floor, so bottom is facing up as shown in Diagram 1. Make sure the top rests flush into the frame.
Step 4: Make sure all bolts are aligned properly before tightening with hex wrench. Be sure bolts
are secure and tight. Place bolt covers over bolts. Then with a second person's assistance, if
needed, carefully turn the table over onto its legs. Be sure legs rest on flat surface.
Step 3: Then attach Table legs (C) to the bottom as shown in Diagram 2, using Bolt(F) and Washer
(G) and Bolt cover(H). Attach Support Bar (D) to Leg (C) using Bolt (E) and Washer (G) and Bolt
Cover (H) as shown in Image 3.
A
Diagram 1
Diagram 2
A
B
G
F
H
C
1 of 2