STUDIO SIDE Table
WDC-STU-02 ST
Assembly Instructions
Step 1: Remove protective wrapping first. Then lay all parts on floor and identify all parts packed in
carton against attached parts list.
Step 2: Lay Table Top (A) upside down on floor, so bottom is facing up. Place a protective soft
material on floor before placing tabletop face down on floor.
Step 3: Then attach each of four legs (B) to the bottom as shown in Diagram 1, using Bolt (C) and
Washer (D) and Bolt cover(E).
Step 4: Make sure all bolts are aligned properly and tightened sufficiently. Then place bolt covers
over bolts.
NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND
TIGHTENED PROPERLY AND SECURELY.
Diagram 1
A
B
D
E
C
1 of 2
