This swivel dining chair consists of a seat bucket and a round base which need to
be attached together prior to use. PLEASE FOLLOW BELOW INSTRUCTIONS TO
ATTACH BASE TO SEAT WITH BETTER EASE.
1) Lay out all the parts from box and hardware bag on the floor before beginning assembly.
2) Place seat bucket (A) upside down on floor as shown in diagram. Use protective cover on floor
first before placing seat bucket down to avoid any scratching to chair.
3) Take base (B) and position it to the bottom of seat bucket (as shown) so that the two holes in
each of the two SPRING PLATES align to the holes in the BOTTOM BAR of the seat bucket.
4) Place a rectangular steel plate (G) on top of each SPRING PLATE that is attached to base (B)and
then slide the four bolt screws (C) through the holes of steel plate (G) and then through BOTTOM
BAR as shown in Diagram 1. This will help allow the base to stay in place on top of bar, while each
screw is then tightened on the other side of the BOTTOM BAR with washers and hexnuts.
5) Position rectangular steel pate (G) underneath the BOTTOM BAR so each pair of bolt screws (C)
go through steel plate's holes followed by washer (D) and spring washer (E) and hexnut (F) as
TRAVERS Swivel Rocker
WDC-TRA-62
Assembly Instructions
Ref
Part Name
Part Image
Qty
Ref
Part Name
Part Image
Qty
A
Seat Bucket
1
F
Hexnut 4
B
Base 1
G
Steel Plate
4
C
Bolt 4
H
Hexnut Cover
8
D
Washer
4
I
Bolt Cover
8
E
Spring Washer
4
J
Hex Wrench
2
6) Place bolt head covers (I ) over bolt heads and the hexnut covers (H) over hexnuts.
Turn seat over to its upright position and the chair is ready to use.
g
g
p
y
( )
p
g
( )
( )
shown in Diagram 1. Tighten hexnut to bolt by holding bolt head in place with one hex wrench while
turning hexnut clockwise until securly tightened as shown in Diagram 2. Be sure each bolt screw is
tightened very well.
PARTS LIST
1 of 2
