OPERATION
Blade Guide Arm Adjustment
Operation
MHdoc031016
2-14
2
CAUTION!
Make sure all guards and covers are in place
and secured before operating or towing the machine.
Failure to do so may result in serious injury. Be sure the
blade housing cover is in place and secured.
NOTE:
After aligning the blade on the wheels, always
check the blade guide spacing and location.
2.7
Blade Guide Arm Adjustment
The blade guide arms can be adjusted up or down depending on the height of the
material to be cut. The arms should be adjusted about 25 mm (1”) above the material to
be cut.
See Figure 2-6.
To move the blade guide arm, unlock the safety pin and slide the arm up
or down. Lock the lock pin.
FIG. 2-6
tvs_248
Blade Guide Arm
Lock Pin
Summary of Contents for TVS-FT Series
Page 1: ......
Page 2: ......
Page 26: ...OPERATION TVS Setup 2 2 9 MHdoc031016 Operation FIG 2 3 ADDITIONAL INFEED TABLE...