Maintenance
Belt Conveyor Alignment
5
5-7
EGdoc013119
5.4
Belt Conveyor Alignment
The belt conveyor is factory-aligned. Periodically check and realign the conveyor belt if necessary. Make
sure the belt remains centered on the drive roller and idle wing pulley while running. If the conveyor belt
keeps travelling to the side of the drive roller and/or idle wing pulley, follow the alignment procedure
below.
To align the conveyor belt:
4.
Loosen the jam nuts on one or both idle wing pulley adjustment bolts.
See Figure 5-1.
5.
Turn one of the adjustment bolts clockwise to move the idle wing pulley downward and away from the
side being adjusted. Turn the adjusted bolt counterclockwise to move the idle wing pulley upward.
6.
Start the drive roller motor and check if the conveyor belt still needs to be aligned. Repeat the adjustment
procedure until the conveyor belt stays in place on the drive roller and idle wing pulley while running.
7.
Tighten the jam nuts when the belt alignment procedure is complete.
Periodically check the conveyor belt for wear. Replace the belt if damaged or worn. Always check the
conveyor belt alignment after installing a new belt. Align the conveyor belt after replacing if necessary.
FIG. 5-1
0
Turn the adjustment bolt clockwise to move
the belt away from the side being adjusted
Loosen the jam nut to
adjust the belt
0
Summary of Contents for Titan WB2000-EC
Page 1: ......
Page 2: ......
Page 30: ...Setup Operation Sawmill Setup 4 4 4 EGdoc013119 FIG 4 3 WB2000 hes_017_A Lifting brackets...
