Sawmill Operation
Replacing The Blade
Operation
EGdoc013119
3-3
3
Key Switch:
“0” position - all electrical circuits are off. “M” position - all electrical circuits are on. “B”
position - all electrical circuits are off and main motor disk brake is released; it is possible to spin the
blade wheels by hand.
Main Motor On/Off Switch:
Turns on and off the main motor. The light between switches is glowing
when the blade is engaged.
Laser indicator switch with control light:
Turns on and off the laser indicator. When laser indicator is
on, control light is glowing.
Debarker blade switch with control light:
Turns on and off the debarker blade. When debarker is on,
control light is glowing.
Blade Guide Switch:
Used to adjust the blade guide roller.
Feed Rate Adjustment Knob:
The speed at which the saw head travels forward is adjusted by the feed
rate knob.
Debarker Arm Control Switches:
Moves the debarker arm in or out from the log.
Board Removal Plate Switch:
Enables to select board removal direction.
Power Feed Switch:
Push the power feed switch down to move the saw head forward. Push the power
feed switch up to move the saw head back.
Up/Down Switch:
Moves the saw head up and down and to switching automatic modes.
3.2
Replacing The Blade
DANGER!
Always shut off the sawmill motor before changing the blade.
Failure to do so may result in serious injury.
WARNING!
Always wear gloves and eye protection whenever handling
bandsaw blades. Changing blades is safest when done by one person!
Keep all other persons away from work area when changing blades.
Failure to do so may result in serious injury.
WARNING!
In case of blade or drive belt break, wait until all rotating parts
are completely stop. Failure to do so may result in serious injury.
Move the blade guide arm out.
Open the blade housing covers. Release the blade tension
and the blade is lying loose in the blade housing. Carefully lift the blade out of the blade housing.
When installing the blade, make sure the teeth are pointing the correct direction. The teeth should be
pointing toward the operator side of the mill when you are looking at the blade below the blade guides,
as shown on the label located on the blade housing.
Position 3.5” (90mm) wide blades on the wheels so the gullet is 1/8” (8 mm) out from the front edge of
the wheel.
Close the blade housing cover. Next, use the blade tension handle to tension the blade correctly.
CAUTION!
When adjusting the blade position, be extremely careful,
because your fingers can get pinched.
Summary of Contents for Titan WB2000-EC
Page 1: ......
Page 2: ......
Page 30: ...Setup Operation Sawmill Setup 4 4 4 EGdoc013119 FIG 4 3 WB2000 hes_017_A Lifting brackets...
