MAINTENANCE
Miscellaneous
3
3-5
25doc092506
MAINTENANCE
3.6
Miscellaneous
1.
Apply a thin film of a lithium grease to the blade guide arm to help prevent it from rusting.
2.
Lubricate the log turner (if equipped) with a lithium grease every fifty hours of operation.
Lubricate the turner pivot points (e.g. with WD-40).
3.
Grease the side supports with a lithium grease every 50 hours of operation.
4.
Oil all chains with an easily penetrating oil such as WD-40.
CAUTION!
Do not use chain lube. It causes sawdust
buildup in chain links.
5.
Check the mill alignment every setup. See Section 5, Alignment.
6.
Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any
damaged or unreadable decals immediately. Order decals from your Customer Service
Representative.
50
50
50
50
