Operation and Maintenance
Locking Pin Operation
Operation and Maintenance
DB17doc072219
4-1
4
SECTION 4 OPERATION AND MAINTENANCE
4.1
Locking Pin Operation
See Figure 4-1.
The debarker is equipped with a locking pin located where the debarker
frame pivots in the mounting blocks. One hole location is provided for the locking pin.
Turn the locking pin to the left to lock the debarker in place when towing the sawmill. Turn
the locking pin to the right to unlock the debarker while the debarking is required during
sawing.
Before operating the debarker,
make sure the locking pin is secured in its travel posi-
tion. Turn the key switch to OFF (0) and remove the key. Pull the debarker out to relieve
pressure on the locking pin. Pull the pin up and rotate so the small roll pin is aligned with
the disengaged position. Release the locking pin.
Before towing the sawmill,
lock the debarker in the travel position. Turn the key switch
to ACC (3) and use the debarker in/out switch to move the debarker all the way in. Turn
the key to OFF (0) and remove the key. Push the debarker in until the travel position hole
aligns with the locking pin. Pull the pin up and rotate until the small roll pin is aligned with
the travel position slot. Release the locking pin.
To move the debarker out of the way during sawing,
turn the key switch to ACC (3)
and use the debarker in/out switch to move the debarker all the way out.
FIG. 4-1
LX0042-8
Locking pin
in disengaged
position
Locking pin
in travel position