SETUP & OPERATION
Up/Down Operation
3
3-19
doc063022
SETUP & OPERATION
3.8
Up/Down Operation
1.
Install a blade and check for correct blade tension.
(
See Section 2.4.
)
2.
Set the cutting head to the desired height. (The blade height scale shows the height of the blade
above the bed rails.)
See Figure 3-13.
The up/down switch is located on the right side of the control panel. Push the
switch up to raise the cutting head; push the switch down to lower the cutting head. Hold the switch
in position until the cutting head reaches the desired height, then release.
The up/down switch is designed to return to the neutral position when released. If the switch remains
engaged, manually move it to the neutral position. Repair the switch.
CAUTION!
DO NOT try to force the carriage above the 35” (88 cm)
mark or below the 1” (2.54 cm) mark. Damage to the up/down system
may result.
FIG. 3-13
20_029B
UP
DOWN