Safety & General Information
Engine/Motor Specifications
1
1-17
25doc063022
Safety & General Information
See Table 1-4.
The performance capacity of the LT20 series sawmill is listed below.
Peak cutting rates are measured in 12” (30 cm) wide red oak and represent the capability
of the sawmill only. Rates based on using Tru-Sharp 1 1/4” x .042 blades.
1.9
Engine/Motor Specifications
See Table 1-5.
The power options available for the LT20 Series sawmill are listed below.
See Table 1-6.
See the table below for power supply specifications for the LT20 sawmill.
DANGER!
It is recommended that a 30mA Ground Fault
Interrupter (GFI) be used.
1
Maximum log capacity for a basic mill is 2000 Kg.
Model
Linear Blade Speed
Maximum Cutting Speed
LT20B3E15SMH
---
5.2 m/min.
TABLE 1-4
Engine/Motor Type
Manufacturer
Model No.
Power
Other Specifications
11HP Electric
Tamel SA,
Poland
Sg 132S-2B HM
7.5 kW
14.5 A, 2925 r.p.m.
15HP Electric
Tamel SA,
Poland
Sg 132S-2PC HM
11 kW
22.3 A 2920 r.p.m.
22HP Diesel
Kubota
D1005
22 HP
3600 r.p.m.
25HP Gasoline
Kohler
CH25
25HP
3600 RPM, 725 cm
3
TABLE 1-5
3-Phase
Volts
Fused
Disconnect
Switch
Recommended
Wire Size
400 VAC
25 Amp
4 mm
2
up to 15 m of length
TABLE 1-6
