Wood-mizer LT15WB D17, Safety, Setup, Operation & Maintenance Manual

Page: 79 / 88

Sawmill Alignment
Blade Guide Arm Alignment
Sawmill Alignment 1510doc071918 5-15
5
See Figure 5-17. Tighten the two previously-loosened tilt adjustment screws to secure the blade
guide assembly.
Loosen the top vertical adjustment jam nut and tighten the bottom vertical adjustment jam nut to
adjust the blade guide roller up so it does not touch the blade.
Blade Guide Arm Alignment
The blade guide arm moves the outer blade guide in and out. If the arm becomes loose, the
blade guide will not deflect the blade properly, causing inaccurate cuts. A loose blade guide arm
can also cause blade vibration.
See Figure 5-18. Use the inside top and bottom screws to adjust the arm up until the slide pad
touches the saw head brace tube. Tighten the jam nuts.
FIG. 5-17
FIG. 5-18
Tilt Adjustment
Screws (4)
3H0802-15
Blade Guide
Shaft Centered
In Block
Top Vertical
Adjustment Jam Nut
Bottom Vertical
Adjustment Jam Nut
Roller Flange
150210-7
Adjust outside top
and bottom screws
with arm
closed
Adjust inside top
and bottom screws
with arm
open