Setup & Operation
Up/Down Operation
3
3-19
15doc091818
Setup & Operation
3.7
Up/Down Operation
1.
Install a blade, if needed, and check for correct blade tension.
).
Set the cutting head to the desired height. (The blade height scale shows the height of the
blade above the bed rails.)
See Figure 3-13.
Use the up/down crank to raise or lower the cutting head.
2.
Turn the up/down lock counterclockwise until it disengages the up/down shaft.
3.
Pull back on the crank handle to engage the locking pins for up/down operation.
4.
Turn the up/down crank clockwise to raise the saw head, counterclockwise to lower the
saw head.
5.
Turn the up/down lock clockwise until it engages the up/down shaft.
CAUTION!
DO NOT try to force the carriage above the 27"
(68 cm) mark or below the 1" (2.54 cm) mark. Damage to
the up/down system may result.
FIG. 3-13
Turn crank clockwise to
raise saw head;
counterclockwise
to lower saw head
Pull crank handle
back to engage
up/down drive
Up/Down Lock Pin
15B008
