Alignment
Horizontal Tilt Adjustment
6
6-17
15doc091818
Alignment
6.10 Horizontal Tilt Adjustment
1.
Finally, both blade guides must be tilted horizontally. Adjust the blade guide arm half way
in.
See Figure 6-14.
2.
Place Blade Guide Alignment Tool against the face of the outer blade guide roller.
3.
Center the tool on the roller and measure between the back edge of the blade and the
ruler at the end closest to the inner blade guide ("B").
4.
Measure between the back edge of the blade and the other end of the ruler ("A").
5.
The roller should be parallel to the blade (A=B) or tilted slightly to the left (A=B-1/4"
[6 mm]).
6.
Use the side set screws to adjust the horizontal tilt of the roller.
7.
Repeat Steps 3 - 7 for the inner blade guide roller.
NOTE:
Once the blade guides have been adjusted, any cutting variances are most likely
caused by the blade.
See Blade Handbook, Form #600.
FIG. 6-14
50cm (19 11/16")
