SAWMILL ASSEMBLY
Saw Head Assembly
2
2-17
15doc091818
SAWMILL ASSEMBLY
2.5
Saw Head Assembly
1.
Position the saw head at the end of the bed frame assembly. Carefully slide the saw head
rollers onto the bed frame track. Keep the saw head square to the bed to avoid putting the
track rollers in a bind.
WARNING!
When setting the saw head on the bed frame,
use extreme care and keep all persons at a safe distance.
Failure to do so may result in serious injury or death.
2.
Position the middle track cover between the two track roller housings so the opening in
the cover is positioned over the feed rope pulleys. Secure with two hex head bolts and
lock washers.
3.
Install a track wiper with a felt strip to each track roller housing using a 8.4 flat washer and
M8x12 hex head bolt.
See Figure 2-9.
4.
Assemble the retaining bracket to the idle side upright with two hex head bolts and flat
washers.
5.
Assemble the two track wipers to the idle side upright using hex head bolt and flat
washer.
NOTE:
Before installing the middle track cover and the remaining felt wipers, soak the felt
FIG. 2-9
