SAWMILL ASSEMBLY
Manual Feed Rope Assembly
SAWMILL ASSEMBLY
15doc121912
2-22
2
2.6
Manual Feed Rope Assembly
1.
Install a feed rope mounting bracket at each end of the bed assembly using a M10x30 hex head bolts and
washers. Either bracket should be angled toward the end of the frame at which it is mounted as shown
below.
See Figure 2-15.
2.
Tie a knot in one end of the feed rope. Slip the knotted end of the rope into the front rope mount bracket.
Route the rope between the saw head and main bed frame tube.
See Figure 2-16.
FIG. 2-15
FIG. 2-16
150110F
M10x30
Bolt
Front Rope Mount
Bracket 502725-1
(LT15-EC 508237-1)
10.5 Flat
Washer
Rear Rope Mount
Bracket 502726-1
(LT15-EC 508236-1)
M10x30
Bolt
10.2 Split
Washer
10.2 Split
Washer
10.5 Flat
Washer
15B007d
