SETWORKS OPERATION
Start-Up Settings of the Controller
SETWORKS OPERATION
EGdoc031621
4-2
4
Descriptions of the control panel buttons:
A, B, C, D, E - cutting width memory buttons
SET ABCDE - used to set a cutting width value under each memory button.
Save - saves parameters determined by the operator.
Buttons for manual cutting width setting (blades in/out)
ENTER
– enters a value into the controller memory.
Auto Mode – Adjustment of the Setworks automatic calibration parameters. Used for the initial
calibration and re-calibration if a dimensional error occurs.
Set Real Size - used to set the real distance between the blades. This setting should be made when
the “Check real size” indicator light is blinking.
IMPORTANT!
Do not use too much force or any hard object to press the
buttons. The controller is not water-resistant.
4.2
Start-Up Settings of the Controller
1. Setting the input divider (entered only once, at the first start-up)
Switch on the controller by turning the main switch to the ON position.
When ”TBS-01” appears on the display, press and hold
until the divider value appears on
the lower right display.
Enter the correct value of the divider (for the Edger the divider value should be
5
).
A
SET
ABCDE
SAVE
ENTER
AUTO
CAL.
SET
REAL SIZE
AUTO
CAL.
