Setup & Operation
Control Setup
Setup & Operation
AS00doc032519
2-2
2
2.1.1 Contrast Adjustment
When the Accuset is first powered on, the Adjust LCD Contrast screen is displayed for a
few seconds. Push and hold the Up or Down button to adjust the display contrast as
desired for your lighting conditions. To save the new contrast setting, push the Up arrow
button and push Save Settings, then Save Now.
2.1.2 Standard Sawmill Model Configuration (Rev. E.02+ Only)
The Accuset is programmed for operation with Super model
sawmills by default. If your sawmill is a Super model, skip to
Initial Setup. If your sawmill is a
Standard
model, the
Accuset needs to be reprogrammed. Follow the instructions
below.
Turn the key switch off (#0). Press and hold the Toggle button and turn the key switch to
the accessory (#3) position and select Standard from the menu.
See Figure 2-2.
Procede to Startup Configuration.
2.1.3 Startup Configuration
Accuset controls on new sawmills are configured at the factory. If you have installed or
replaced the control, be sure to configure the control before operating the Accuset. Follow
the procedures below
in the order they are listed
.
FIG. 2-2
Default
OVERWRITE TO DEFAULT
3H0821-14
Push and hold Toggle
button during startup to enter
setup menu
Standard
No
Push to reconfigure for use
with Standard model sawmills
OVERWRITE PARAMETERS WITH DEFAULT?
