SAWMILL ALIGNMENT
Vertical Adjustment of Side Supports
5
5-29
doc111517
SAWMILL ALIGNMENT
5.17
Vertical Adjustment of Side Supports
1.
Place a flat board across the bed rails.
2.
Swing a side support up so that it is vertical.
3.
Pull back at the top of the support to eliminate slack as if a log were being clamped against it.
See Figure 5-27.
4.
Check the angle of each support with a square on the board.
5.
The side support should be 90
o
to the bed rails or leaning forward 1.0 mm (0
.
04"). Loosen the top
adjustment bolt, adjust the side support, and retighten the bolt.
6.
Repeat for the remaining side supports.
FIG. 5-27
Square
Side
support
Board
Adjustment
bolt
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
