7
FUEL BED REFITTING
If the fuel bed components are dislodged or removed, they must be refitted as follows:
Only the fuel bed parts supplied with this appliance or authorised Wonderfire replacements must be used. Never add extra
coals above the number stated in these instructions.
1
With its feather
edge at the top, place the
ceramic rear wall into the
channel at the back of the
firebox. Push the wall flat
against the rear of the fire
box. (See figure 3).
2
Place the front base
coal in the burner
compartment so that
it rests on the ledges
at the sides and
front. Pull the coal
forward so that it is
immediately behind
the front rim of the
burner
compartment. (See
figure 4)
.
3
Place the rear
base coal in the
burner compartment
behind the front
coal. It should rest
on the ledge at the back
of the burner
compartment and its
rear face should touch
the rear ceramic wall
(See figure 5)
4
Install the 9 loose
coals as follows. The
smooth surfaces of the
coals should be at the
bottom and back.
4.1
Select the two
smallest coals and put
them aside until all the
other coals are installed.
Place four of the medium
size coals in the four
valleys of the front coal.
Place the left side coal so
that the pilot flame will be
visible. (See figure 6).
4.2
Place the three
remaining medium
size coals behind and
approximately midway
between each of the
coals in the front row
(See figure 7).
4.3
Place the two
remaining small coals
alongside the main
coals (See figure 7)
Fig 7 Small side coals
Fig. 7 Middle row of coals
Fig. 5 Rear base coal
installation
Fig. 6 Front row of coals
Fig. 4 Front base coal
installation
Fig. 3 Ceramic rear wall
installation
