5.6
I/O – LM100/LC100/LR100
The I/O Page is only for the testing, diagnostic the status of analog I/O. All of parameters
will not keep in the device internally once USB connection removed. Diagram 5.6
-
1
shows the I/O setting page for LC. About the available Analog I/O , you can refer the
table 3.1
The I/O setting page includes Current Input/ Output, Voltage Input/Output, PWM Input/
Output information.
Select “Channel” and Click” Read” to import the parameter that read from the channel
selected.
Each type of analog field will show with different color, white color is allowed to perform
“Read” and “Write”, gray color is only for read function.
Some of model provides multiple channels in same type, and then select the target
channel number that you want to monitor or testing.
5.7
RF
The RF page is for radio signal quality monitoring. The RSSI is Radio Signal Strength
Indication, SNR is Signal Noise Ratio. If the RSSI is good, but the SNR is low, the
transmission quality will not good. Therefore, you can adjust the frequency to avoid the
interference of noise. The Diagram5.7
-
1 shows the RSSI, SNR page.
Diagram 5.6
-
1 I/O Configure Page
