Installation Guide & Warranty
Mirror Cabinet
Product Codes
Contents
C22671
C22672
C22673
Mirror Cabinet
1 x Overhead LED Light
C22674
C22675
C22676
2 x Hanging Brackets - fitted
2 x light Fitting Screws
C22677
C22678
C22679
1 x Light Switch & Shaver Socket - fitted
1 x LED Light Driver (A & B)
C22680
C22681
C22982
1 x Shaver Socket Transformer
– fitted (C)
2 x Wall Brackets
Important Information
•
Read the instructions carefully.
•
Ensure product contents are complete.
•
Check the product for any signs of damage and remove all protective film.
•
It is recommended that this product is fitted by a suitably qualified Part P registered electrician in accordance with
current IEE & Building Regulations.
•
It is the installer’s responsibility to carry out a thorough assessment of the installation environment (i.e. wall
type/structure and the weight of the cabinet) and use appropriate fixings.
•
Care should be taken when drilling to avoid any hidden wires or pipes.
•
To prevent the cabinet falling down this product must be fixed using the wall attachment device provided.
•
The light source in this luminaire is not replaceable. When the light source reaches its end of life, the whole
luminaire must be replaced.
•
The terminal block used to connect the leads to the electrical supply can be of either the screw- or screw-less type
and should be rated at 240V 6A with 4 terminals. The cable tails do not need to be crimped when connected to the
terminal block.
•
The driver can be screwed to the internal top rail of the cabinet or left to hang in the void between the cabinet
and the wall.
•
This product should be used only with a mains supply that is protected by a 30mA Residual Current Device.
•
This product is IP20 Rated and is only suitable for installation in Outside Zones in a bathroom, as identified in the
Bathroom Lighting Zones diagram. The product must not be installed within Zones 0, 1 or 2 and where no water jet
is likely to be used.
Installation
Connecting to Mains Electrics
1. Turn off the electrical supply.
2. Fit the overhead light onto the top of the cabinet using the screws provided.
3. Thread the light cable connector through the hole on the top of the cabinet. Do not trail it over the back between
the cabinet and the wall.
4. Connect the cable connector from the overhead light into the connector port on the driver (A).
5. Connect the electrical supply in the bathroom to the driver cable using a terminal block rated at 240V 6A with 4
terminals (B).
6. Connect the electrical supply in the bathroom to the shaver socket cable using a terminal block rated at 240V
6A with 4 terminals (C).
7. Turn the electrical supply back on and check that the overhead light and shaver socket functions as required.
WARNING
RISK OF ELECTRIC SHOCK
Turn off Mains Electric prior to commencing work.
