~
108
~
WARNING!
The power cable and the hoses
must not
be kinked or
bent when installing the appliance in the installation opening.
3.
The free space between the top of the appliance and the worktop
must be less
than 5 mm
; see also chapter 2.9 P
ROPER LEVELLING
.
4.
The door of the appliance must be aligned with the adjacent cupboard doors.
2.9 Proper levelling
❖
The appliance
must
stand in a
stable and level position
to ensure proper
operation. The supporting feet must stand firmly on the ground so that the
appliance does not wobble. Adjust the supporting feet accordingly. The firm
contact of the supporting feet with the ground also ensures that the appliance
does not vibrate or move unintentionally.
❖
The dishwasher must also be levelled horizontally so that the dish racks operate
properly and the cleaning efficiency is guaranteed.
❖
The maximum permissible inclination angle under the entire appliance is 2°.
Adjust the appliance with its supporting feet horizontally. Check with a spirit
level.
H
OW TO LEVEL THE APPLIANCE PROPERLY
1.
The appliance
must
stand in a
stable and level position
to ensure proper
operation.
2.
Place a spirit level on the slide-in rail (
A
) inside the appliance and on the inside of
the appliance door (
B
/ see fig. below) to check if the appliance is level.
3.
If necessary, level the appliance by adjusting the three supporting feet individually.
4.
The
REAR SUPPORTING FOOT
can be adjusted from the front of the dishwasher
by adjusting the
setscrew
(
C 1
) in the centre of the appliance base using a Phillips
screwdriver (s. fig. below).
5.
To adjust the
FRONT SUPPORTING FEET
(
C 2
), use a flat screwdriver and adjust
the front supporting feet until the appliance is
level and stable
.
When adjusting the supporting feet, pay attention to the arrow directions
indicated on the appliance (raising or lowering the appliance).
The free space between the top of the appliance and the worktop
must be
less than 5 mm
.
The
maximum
adjustment height of the supporting feet is
50 mm
.
6.
When levelling the appliance, ensure that it does not tip over.
