![WolfPack HDTVIPA1200 User Manual Download Page 30](http://html1.mh-extra.com/html/wolfpack/hdtvipa1200/hdtvipa1200_user-manual_993719030.webp)
WolfPack 4K IP Streaming Extender
25
5.6
HDMI Audio Routing Tab
HDTV
IPA routes HDMI audio separately from the video signal, e. g. for routing the
audio to additional or different Receivers (RX).
Exception:
In "Genlock Mode", the HDMI audio follows the video when one or more Receivers
(RX) are joined with one Transmitter (TX) from any of the video routing tabs ("Video
Wall", etc.). Simply put: When an RX device is in "Genlock Mode", it receives both the
HDMI video and the HDMI audio signals from a single source. The same also applies
for all video switching modes, when no separate HDMI audio stream is enabled.
To route the HDMI audio signal, select the tab "HDMI AUDIO ROUTING".
All RX devices are listed in the top half of the Receiver (RX) section. Similarly, all TX
devices are listed in the bottom half in the Transmitter (TX) section.
First, verify if appropriate TX and RX units are joined together to route their HDMI audio
signal:
1)
Verify, if the Receiver (RX) is currently joined to an appropriate Transmitter (TX).
a)
Click on the RX to highlight the TX it is joined to in blue.
b)
Selecting the respective TX will highlight all the receivers joined to the same TX.
2)
If the respective Transmitter (TX) is currently not joined to the Receiver (RX),
proceed to join them:
a)
In the Transmitter (TX) section, select a TX by left-clicking on its associated
active tile.
b)
Drag and drop the TX tile over the RX tile to join them.
c)
TX and RX are now joined together.
d)
Repeat above steps, if additional receivers are to be joined to the same TX.
To control, if the HDMI audio is being delivered on the HDMI or the analog output port,
complete the following steps:
1)
Right click the gear icon on a Receiver (RX) tile and select "Settings" in the menu.
2)
To route audio to the HDMI output, select the "HDMI Audio Output"
tab and then
choose one of the following options:
a)
Analog Audio: Select the stream from the analog audio input of the TX to embed
it into the HDMI output signal.
b)
HDMI Audio (Stereo Downmix): Select the audio stream from the HDMI input of