WolfPack 4K IP Streaming Extender
17
All RX devices are listed in the top half of the "Receiver (RX)" section. Similarly, all TX
devices are listed in the bottom half, in the "Transmitter (TX)" section.
5.4.1
Video Switching
This is an example of joining TX and RX devices in "Genlock Mode":
1)
Verify that the RX tile is displaying that the device is currently in "Genlock Mode". If
Genlock is not the currently active mode, apply the setting as described:
a)
Right mouse click the gear icon on the respective Receiver (RX) tile.
b)
In the appearing menu, select "Genlock"
as Video Mode.
2)
Joining the RX to TX.
a)
In the Transmitter (TX) section, select a TX by clicking on its associated active
tile using the left mouse button.
b)
Hold down the left mouse button and drag the TX tile over the RX tile it is to be
joined with. Then release the mouse button to drop the TX tile onto the RX tile.
c)
TX and RX are now joined.
The video source connected to the Transmitter (TX) now appears on the display
connected to the respective Receiver (RX).
If the video is not being displayed, please verify the following:
Ensure that the network switch has been properly configured.
