2
No.
Name
Description
On: The corresponding video signal is valid and is being output.
Blinking quickly: The corresponding video signal is valid but is not being output.
Blinking slowly: The corresponding video signal is being output but is not valid.
Off: The switcher is in standby mode. / The corresponding video signal is neither
valid nor being output.
4
HDMI 2
Output
HDMI2 Output button: press to switch between Follow mode and Matrix mode for HDMI
Output 2.
To switch to
Follow
mode: long press the HDMI2 Output button until the Follow
LED lights up. In Follow mode, HDMI OUT 2 follows HDMI OUT 1 to output the same
video content as that of HDMI OUT 1.
To switch to
Matrix
mode: short press the HDMI 2 Output button. In Matrix mode,
HDMI OUT 2 will output a specific video source in single view (specified by Telnet
API or Web UI); continue to short press the button, the HDMI OUT 2 will cycle
through the hardware video sources (VGA > HDMI 1 > HDMI 2 > USB-C >
VGA >
…
) for output.
LED Status:
Follow LED: Lights up when Follow mode is selected.
Matrix LED: Lights up when Matrix mode is selected.
5
USB
Connect to a U-disk for firmware upgrade.
Connect to the USB Dongle for pairing up with each other.
6
Reset
Hold press this button for five or more seconds and then release, it will automatically
reboot and restore to its factory defaults.
Rear Panel
8
7
6
11
10
9
5
2
4
3
1
1
No.
Name
Description
1
Antenna
Connect to the antenna pair provided for the access to Miracast and soft AP function.
2
DC 12V
Connect to the power adapter provided.
3
VGA In
Connect to a VGA source for video input as well as analog audio input.
4
HDMI In 1-2
Connect to an HDMI source device.
5
USB-C In
Connect to a USB-C video source.
6
USB Hub
Connect to the USB device (e.g. mouse, keyboard, USB audio) for USB extension between
USB device and USB host.
7
USB Host
Connect to USB host device for USB extension between USB device and USB host.
8
RS232 1-2
•
RS232-1: Reserved.
•
RS232-2: Connect to a RS232-enabled device such as a projector to control the
projector.
Pins TX, RX, GND are used to control the connected projector.
Pins 12V, GND are used to provide 12VDC power.
9
LAN
Connect to a network device (e.g. network switch, router, computer, etc.) for LAN control
(Web GUI & Telnet API) and Airplay Mirroring signal input.
10
Audio Out
Connect to an audio receiver (e.g. amplifier) for audio output.
11
HDMI Out 1-2
Connect to an HDMI display device.
