Page 13
Gas Cooktop (CTG) Series
Gas Cooktop (CTG) Series
Installation Information
2-8
#802985 - Revision E - August, 2011
SUPPORT KIT FOR DOWNDRAFT INSTALLATION PROCEDURE
(Refer to 2-14 Below)
These instructions contain procedural information to install the Integrated Cooktop Support Kit for downdraft ventila-
tion installations.
NOTE:
This kit does not include the Filler Strip Kit Assembly. Please order Kit Model number: 803386.
1.
Locate and center the Rear Bracket Support (1) in the downdraft cutout as shown.
2.
Position the Rear Bracket Support (1) so that the top surface is flush with the counter top. You may need a
straight edge to assist in locating the bracket at the correct height.
3.
Mark the center of the elongated slots of the Rear Bracket Support (1) at both ends on the countertop.
4.
Mark the center of the elongated slots of the Filler Strip Bracket (not included) on the front of the cooktop cutout.
5.
Using a 3/32" drill bit, drill a 3/4" deep pilot hole for the #6/32 mounting screws (3)
Figure 2-14. Support Kit for DownDraft Ventilation Installation.
3
1
2
2
Filler Strip Bracket
Not Included
CENTER OF
CUTOUT
Filler Strip
Not Included
Not Included
6.
Install the Downdraft into the countertop opening, but do not secure in place at this time.
7.
Secure the Rear Bracket Support (1) and Filler Strip Bracket (not included) to the countertop using items (2 & 3).
8.
Install Integrated cooktops into the corresponding openings.
9.
Position the Filler Strip (not included) into the Filler Strip Bracket (not included) and install the three #10-24
nuts, but do not tighten.
10. Align and adjust cooktops, downdraft and filler strip in the counter top opening and then tighten cooktop hold
down clamps, filler strip nuts and secure the downdraft per installation instructions.
PLEASE CONSULT WITH THE COUNTERTOP MANUFACTURER/INSTALLER FOR PROPER METHOD OF
INSTALLING SCREWS INTO INSIDE EDGE OF COUNTERTOP. DAMAGE MAY OCCUR IF PROPER METHODS
ARE NOT USED.
