Page 119
Analog I/O Card
Analog Rear Panel Adaptor
After adding the Analog I/O Card and its corresponding rear panel adaptor to the
AMP2-16V, the rear panel adaptor provides the connectors shown in Figure 6–4.
Figure 6–6: Analog I/O Card Rear Panel Adaptor and Rear Card Cover Plate
Menu Modifications
You can select the analog input from the Monitor Mixer Configuration Menu and
also from the AES and Analog Output Menus.
The Audio Processor Configuration Menu will now display an Analog I/O knob.
Pressing this knob will display the Analog Output Configuration Menu from which
you can select and configure the outputs.
Note:
You can modify the analog reference levels in the Hardware Configuration
Menu.
Connector Pin Outs
Note:
The balanced analog input connector pin out is the same as the
commercially-available Tascam DA-88 adapter cables.
