www.wobit.com.pl
User manual SID116 – 09.04.2015r. v.1.0 page 4
1.
Safety and assembly rules
1.1
Safety rules
1.
Prior to first start-up of the device please refer to this manual and keep it for further use.
2.
Provide appropriate working conditions in compliance with the device specification ( e.g.: power supply
voltage, temperature, maximum current consumption).
3.
Protect inside of the device from any liquids or elements – it can cause electric shock and damage of the
device.
4.
Basic features which knowledge and use will provide safe use consonant with its designation will be
demonstrate on the device or in this manual.
5.
The device with its parts is manufactured in way to provide its safe mounting and connection.
6.
The device is designed and manufactured as to conform to the principles of protection against the threats
mentioned above provided that the device is used in a manner consistent with its purpose and that it is
properly maintained.
7.
The device can cause interference of sensitive radio and television devices in nearby.
1.2
Assembly recommendation
It is recommended to follow measures described below to prevent any possible interruptions of the device
operation:
Do not power the driver on the same line as the device without a corresponding high power line filters
(drivers/servo motors).
Minimize influence of external interference.
To minimize noises
please use
screening
of the cable connecting motor with a driver. It is recommended
to use a
ferrite bead
assumed on the motor wire in close to the driver.
Encoder cable should be screened and shouldn’t lead in close of motor cables.
Signal cables
shouldn’t lead in close to motor cables
and should be possibly short
.
While using servomotors supplied from the same power line please equip it in proper filters to eliminate
noises which can influence on driver operation. Use of filters can be also necessary while occurring other
noises from power line.
Picture. 1. Recommended mounting position
While mounting it is recommended to keep proper driver position to provide proper heat dissipation. It is
recommended mounting with space minimum 50 mm from next device to provide proper air circulation.