_________________________________________________________________________________________
www.wnt.com
XND.00016.022_A - 04/2018
26
5
Covers
5.1.1
Closing plugs for unused locating holes
Closing plug Ø40
-a-
for holes of alignment bolt
-b-
.
Insert
closing plug Ø40
-a-
, with holding groove
and M4 turning thread
into the MNG modul
-b-
.
By operating the clamping spindle (approx..
4 turns), the clamping bolt is pressed into groove in
the closing plug, closing the MNG module.
Important:
Tighten the clamping screw only lightly.
5.1.2
Closing plug for unused grid holes
M12 closing plug with O-ring
-c-
for drill holes
-d-
.
Turn the M12 closing plug with O-ring
-c-
into grid
hole
-d-
until it no longer protrudes from the surface of the plate.
Important:
The closing plug must not protrude from the surface of the plate.
6
Interface for alignment bolt
-b-
-d-
-a-
-c-