_________________________________________________________________________________________
www.wnt.com
XND.00016.022_A - 04/2018
24
4
Operation (standard operation)
4.1
Clamping / aligning
4.1.1
Clamping on 400x400 machine table with T-slots spaced at 63 mm
Position MNG plate with centring bolt
-a-
on machine table.
Use the alignment pin
-b-
to fix the axis.
Insert the slot nuts
-c-
into the machine table and fix with cylinder screw
-d-
.
4.1.2
Aligning a MNG plate without centring bolt and alignment pins
When working without the centring bolt and alignment pins, the plate has to be aligned
using the position holes.
Important:
The outer edges cannot be used as reference edges. Please use the position holes for aligning
the plate.
4.1.3
Alignment with several MNG plates
When clamping with several zero point clamping systems, the first plate is positioned and
clamped as described in 4.1.1 or 4.1.2. For the alignment of a second plate, this must first be
approximately aligned to the first plate.
For exact positioning it is possible to use an alignment aid.
Tip:
Please contact our field sales if you wish to order an alignment aid.
-d-
-b-
-a-
-c-