Safety
Original-Betriebsanleitung
HD1+HD2
6
•HD1-2_BAoDB_en_1407•ski
The machine may only be operated within the prescribed limits and machine
parameters.
2.4.2 Danger caused by attachments and spare parts
If you use original attachments and original spare parts from
, the
compatability with our equipment is guaranteed. It is, however, essential that
the safety regulations of the attachments and spare parts are observed. You
can find these safety regulations in the User’s Handbook located with the spare
parts lists.
If you use attachments and spare parts from another source,
cannot
guarantee the safety of the entire system. In this case, our guarantee does not
cover any damage or injury caused by such attachments and spare parts.
2.4.3 Emissions
It is possible for solvent vapours to occur, depending on the materials used.
Therefore, please ensure the workplace is sufficiently ventilated in order
to avoid damage to health and property. Always observe the processing
information given by the material manufacturer.
The sound pressure level of the equipment is below 85 db(A).
Nevertheless, appropriate means of noise protection should be made available
to the operating staff.
The operator is responsible for compliance with the rules covering the
prevention of accidents due to „noise“ (VGB 121). Therefore, pay special
attention to the environmental conditions at the site, e. g. noise can be
increased if the machine is installed in or on hollow bodies.
Exact details regarding noise emission are mentioned in the Chapter 9.1
Technical specification.
2.5 Sources of danger
Remember that
Injection Pumps work under extreme pressures
and that they can cause life-endangering injuries if used inappropriately.
Pay attention to the following notes:
➤
Material hoses must conform to the prescribed maximum working pressure,
allowing for a suitable safety factor.
Material hoses are never to be „patched“!
➤
Never point the injection lance towards yourself, other people or other living
creatures.
➤
Never hold your finger or hand in front of the injection lance and never reach
into the injection stream.
➤
Never try to seal leaks on joints and high pressure hoses with your hand
or by binding the spot. Should a leak occur, the whole system (injection
lance, hose, pressure filter, pump, etc.) is to be depressurized immediately.
Defective parts are to be replaced.
➤
Shut off the injection lance at every pause in working, regardless how short.
