Start up
13
Original-Betriebsanleitung
HD1+HD2
•HD1-2_BAoDB_en_1407•ski
4 Start up
4.1 Set-up and Assembly
Task
You wish to erect the machine at the site and prepare it for operation.
Prerequisite
➤
The material to be worked with is prepared.
➤
All materials to be sprayed should be marked with information on viscosity,
processing temperatures, mixing proportions etc. If this is not the case,
please, acquire this data from the relevant manufacturer.
➤
The material to be sprayed must be slowly but thoroughly stirred before
beginning to work.
➤
When dealing with two-component materials, the potlife life must be
observed. The machine must be flushed and completely cleaned with the
specified cleaning agent within the potlife life as given by the manufacturer.
Please, observe that the hardening time shortens at higher temperatures.
It is recommendable to allow the solvent to circulate for a while. It must be
made certain that no particles of paint remain in either the pump or the filter.
Procedure
1.
The machine is to be set up securely on a level and solid surface. All
operating elements must be easily accessible. In order that the necessary
volume of air is guaranteed, the compressor capacity must comply with the
amount of air needed by the machine and the diameter of the air supply
hoses must correspond to the joints.
2.
Several components of the machine were dismounted and packed in a
separate carton for shipping (i.e. fluid hose, injection lance, air pressure
regulator).
Assemble these components as described in chapter 3.
3.
Inspect all turnable parts, nuts, screws and hose connections and pull on
them tightly to ensure that no material could leak out of these fittings which
could lead to injuries.
4.
Please, check the permissible maximum air pressure for the material hose
and injection lance. It must be greater than or equal to the maximum
operational pressure for the system, which is shown on the nameplate on
the high pressure pump or on the machine card (chapter 9.4).
5.
Compare the maximum operating pressure of the safety valve with the
information on the machine card (chapter 9.4) or the nameplate. This
information must correspond.
