Gearless Lift Machine
WSG-S2.4
Operating Instructions
Code
GM.8.003290.EN
Date
13.06.2016
Version
0.10
Page
21
Subject to changes without notice ! Subject to changes without notice !
EN
6.8. Replacing the measuring system
The measuring system is only accessible from the rear side of the motor.
See the mounting instructions for the Kübler encoder.
Disassemble the measuring system only if this is necessary because of a defect. Remember to readjust the off set
value after reassembly (see the inverter operating instructions).
Disassembly
1.
Loosen 2 x bolts.
2.
Remove 2 x bolts with
washers.
3.
Loosen fixing bolt.
4.
Unscrewing the fixing bolt cau-
ses the encoder to disengage
from the motor shaft.
Assembly
1.
Screw the fixing bolt into the
motor shaft. This causes the
encoder to be drawn into
the cone.
2.
Tighten the fixing bolt
with 3
+0.5
Nm.
3.
Attach the encoder with 2 x
bolts and washers.
4.
Tighten the 2 x bolts.
