WittRock Integris 2002, Service Manual, Page: 71 / 452

4.3 Single Receptacle
Chapter 4: Removal, Replacement, and Adjustment Procedures
Figure 4-4. Single Receptacle Removal
4
m142a014
4. Remove the insulator (D), if so equipped.
5. Loosen the receptacle screws (E) until the single receptacle (A) will lift
away from the device plate.
6. Note and record the positions of the color-coded wires (F).
7. Unscrew the wire terminal screws just enough to remove the color-coded
wires (F) from the single receptacle (A).
Replacement
1. Install the color-coded wires (F) to the proper terminals on the receptacle
(A).
2. Tighten the terminal screws on the single receptacle (A).
Integris® 2002 Headwall System Service Manual (man142rb) Page 4 - 9