Wittke TWIN AUGER, Operator'S Manual

Page: 72 / 87

64 Operating the W
ITTKE
T
WIN
A
UGER
™
Figure 4-7 Rubber bump stop
N
OTE
:
Be aware of the required overhead clearance at all times.
2.
Retract the forks fully until the Arms Not Stowed indicator light on the control panel turns green
(see Figure 3-16).
3.
Turn OFF the hydraulic pump (see Pump Switch on page 45) to reduce the engine load between
stops.
N
OTE
:
Switch the hydraulic pump to OFF if your route destination is more than 1 mile (1.6 km) away.
Exhaust Regeneration Process
To get more details about exhaust regeneration process, please refer to the chassis manufacturer’s
documentation.
N
OTE
:
During the exhaust regeneration process, the operator must raise the arms until they rest on
the rubber bump stops. Failure to do so will cause damage that are not covered by warranty.
Arms and forks in safe driving
position